Wear is one of the most common and most numerous failure modes of a machine. No matter what product is produced, the parts which are in contact with each other during operation will be friction due to the relative motion, and the wear is due to the result of friction. Even to get the rapid development and widely application of electrical discharge machining (EDM) also wear, EDM method although can adapt to the needs of the development of production and in the application shows many excellent properties, but also can not avoid emergence of the wire EDM wear parts. It is precisely because of wear and tear caused by the loss of surface layer material, the size of the parts changed, directly affect the service life of parts. Therefore, in the production process, in time for the maintenance of the spark machine is very important, and that how to Wire edm wear parts wholesaler? Here tomake a brief introduction of spark machine maintenance knowledge.
Maintenance can be divided into routine maintenance, mechanical parts to the first level maintenance, mechanical parts, such as two

maintenance. Here to talk about the daily maintenance, that is, one day to maintain, of course, do not go to work on weekends to maintain.

A day can be divided into before work, work, work in the maintenance:
1 before work:(1) check the buttons and switches, buttons, etc., the requirements of flexible and reliable, accurate location;(2) check the safety device, fastening device, the requirements of accurate, flexible, reliable, no loose;(3) check all kinds of instruments, the requirements of the correct, sensitive;(4) check the oil level, oil or grease lubrication chart according to the road, the amount of oil to meet the requirements;(5) the execution engine operation, each part should fully exercise and lubrication.
2 work:;(1) the implementation of operational procedures, to strictly abide by(2) at any time to listen, look, touch, smell, observe the operation of equipment, to timely treatment, without trouble running.
3 after work:(1) cleaning chip, wipe the appearance, the taper hole of the main shaft and the sliding surface, more than three days not to anoint rust, to strictly abide by.(2) each moving parts, buttons and switches in a reasonable position to strictly comply with;(3) cut off the power supply and air source, must be strictly observed;(4) clean up the environment around the machine tool, without obstacles.
Weekend
Weekend maintenance:Wipe all parts (including the operation of the panel, buttons, etc.), check the cleaning and filtering device, according to the slip table, while adding coolant to check whether the loosening of fasteners. Cleaning of spindle hole. Must be strictly abide by these.
Regular maintenance of the spark machine is equivalent to maintenan the wire edm wear parts, so that it can delay the use of the wire edm wear parts, so it is very important to understand the know ledge of the Wire EDM Wear Parts,.What's more ,if you want to know more of the EDM Accessories knowledge could login KENOS official website .

About KENOS

KENOS responsibility is to ensure that dealers have sufficient profit space, protect the interests of dealers and agents.Dongguan KENOS Hardware Technology Co., Ltd. is an enterprise specializing in manufacturing and wholesaling WEDM-LS commonly used products, including consumables and spare parts such as WEDM-LS filter,Power Feed Contact,Wire Guides ,ion exchange resin, insulating plate.

yizeedm12

Dongguan KENOS Hardware Technology Co., Ltd.
Address:Hexing Road No.122, South Shatou District, Chang'an Town,Dongguan City, Guangdong Province,China(Mainland) [CN] IP:162.158.255.198
Hotline:+86-769-89046066
Fax:+86-769-81551393